Product Features: No special too, no drilling or screws required. Easy to Install, double side adhesive tape available for installation. Super bright LED, energy-saving, long life, over 50,000 working hours. High temperature resistant, more security, and stability. LED lights less heat radiation, low power consumption. Wiring Connect: Red Line-ACC V+ Black line-VCC V- Yellow line/L-Left Turn V+ Yellow line/R-Right Turn V+ White Line-Brake V+ Green line-Width Lamp V+
Product Specification: Type: Rear Windshield LED Third High Brake Light Tail Lamp Voltage: DC12V Light Source: LED Color: Red Length: Approx. 103cm/40.6inch Fitment: for all most Cars Waterproof: Yes, IP68 Functions: Brake + DRL Drive light+ Turn Signal; With Flash, Flow Modes How to Install: 1. Please use detergent or alcohol to clean the surface of the target area before you stick it on. 2. Use the hairdryer to heat the tape a little. 3. Stick it on and keep your car non-washed. within 48 hours to achieve the best adhesiveness. 4. Try to finish the steps one time, do not peel off from one area and stick on another area to avoid bad adhesiveness. Note: Please measure your rear window size before you buy this product. This item is approx 103cm/40.6inch.
Product Includes: 1 x Rear Windshield LED Third High Brake Light Tail Lamp
⚠️WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. www.p65warnings.ca.gov
